Observation Logs

10 entries · 4 today

2Session
1Student
2Equipment
1Bench
1Help
3Observation
Today4 entries
Help request raisedHelp
10:32 AM·Dr. Aamir Khan·Digital Electronics Lab (EC-204)· B-08

Arman Khan requested assistance — JK flip-flop toggling incorrectly at Bench B-08. Clock pulse width appears too narrow.

#timing#follow-up
PSU fault observedEquipment
10:14 AM·Dr. Aamir Khan·Digital Electronics Lab (EC-204)· B-04

Bench B-04 power supply tripped on OCP at 2.8 A. Output fell to 0 V. Marked for repair; do not use until cleared.

#PSU#fault
Sequential logic pacingObservation
09:58 AM·Dr. Aamir Khan·Digital Electronics Lab (EC-204)

Students are spending more time than expected on JK flip-flop truth tables. Consider extending the practical by 15 minutes next session.

#pacing#curriculum
Session startedSession
09:45 AM·Dr. Aamir Khan·Digital Electronics Lab (EC-204)

Digital Electronics Lab (EC-204) started on time with 24 students checked in across 18 benches.

#start
Yesterday4 entries
Attendance issueStudent
4:02 PM·Dr. Aamir Khan·Data Structures Lab (CS-302)· B-18

Vikram Joshi absent without notice — third miss this month. Flagged for advisor follow-up.

#attendance#follow-up
Bench B-09 clearedBench
2:35 PM·Dr. Aamir Khan· B-09

Bench B-09 flagged for maintenance — PSU replacement on order. Bench blocked in the assignment grid.

#maintenance
DMM calibration overdueEquipment
11:20 AM·Dr. Aamir Khan· B-06

Fluke 117 (DMM-0117-0048) at Bench B-06 passed its calibration window. Restricted for graded measurements.

#DMM#calibration
Lab coat complianceObservation
10:05 AM·Dr. Aamir Khan·Digital Electronics Lab (EC-204)

Two students in EC-204 without lab coats. Verbal warning issued; remind at start of next session.

#safety
22 Sep2 entries
Session completedSession
12:05 PM·Dr. Aamir Khan·Analog Circuits Lab (EC-201)

Analog Circuits Lab (EC-201) completed successfully. 22 of 22 students evaluated.

#completion
Improvised setup workedObservation
11:48 AM·Dr. Aamir Khan·Analog Circuits Lab (EC-201)· B-03

Bench B-03 used a jumper wire in place of a broken BNC connector — worked well. Replace the connector during next maintenance cycle.

#improvisation#maintenance
3 equipment / bench entries logged recently.